Motorsport Accessories, Motorsport Bonnet catches, fia motorsport parts

6 POLE F.I.A BATTERY MASTER CUT OFF SWITCH AND RESISTER, WHICH ISOLATES ENGINE AND PROTECTS ALTERNATOR CIRCUIT AGAINST HEAVY VOLTAGE SURGE AND PREVENTS ENGINE RUN-ON. CONTROLS CIRCUITS UP TO 500 AMPS INITIAL LOAD WITH 100 AMPS CONTINUOUS LOAD 12-24V. SPARE KEYS ARE ALSO AVAILABLE.

These Graystone belt fittings are supplied to most major harness/seatbelt manufacturer, and are used by most road/race/rally etc works teams.

COMPETITION BONNET PIN

AS USED BY MOST MAJOR WORKS RALLY TEAMS

ALLOY COMPETITION BONNET PIN KIT

	Slide plate and pins manufactured from very strong lightweight high tensile aluminium. Used by most major works rally teams. Quick release slide action for securing bonnets, tailgates and boots. Blue,Black,Red,Gold,Silver 14.99	MICRO BONNET PINS AVAILABLE SHORTLY
			A smaller more compact version or our more familiar GE52 range of bonnet pins. Slide plate is made of anodised aluminium. Pins are made of zinc plated steel. GE33B Blue GE33R Red GE33S Silver . . >

SELF ADHESIVE ALUMINIUM BONNET PINS

This photo shows proportional difference of slide plate GE52
and GE33 Micro Bonnet Pins.

........
.
Manufactured from anodised aluminium and held in place by high quality self adhesive pads shaped to suit. these self adhesive bonnet pins will give your car that authentic works rally look.
GE32B Blue
GE32R Red
GE32S Silver

From £12.49

GE58 QUICK RELEASE BONNET PINS

	Traditional type of quick release bonnet/boot fastener for securing bonnets and boots. Chrome plated steel with full fitting kit included £8.49

GE52 COMPETITION BONNET PIN KIT

Slide plate is manufactured from stainless sleel. Used by most major works rally teams. Quick release slide action for securing bonnets tailgates and boots.
£12.99

COMPETITION BOOT SPRINGS

Suitable for use on boots, bonnets, panels and exhaust systems.
GE53 >>Stainless Steel
GE53B Black coated Stainless Steel

GE54 BATTERY CUT OFF SWITCH

300 amp initial load, 100 amps continuous 12-24v battery cut off switch. A simple way to isolate vehicles electric's in case of fire or accident. Also when fitted, in can be used as an anti theft device and stops drain on the battery when the vehicles or equipment are not in use. £8.99

GE76 METAL BATTERY CUT OFF SWITCH

	12v or 24v metal bodied fixed key battery cut off switch rated at 12v 100 amp continuous loading, 500 amp for 10 seconds.
	£14.99

COMPETITION ' T ' PULL CABLES

1.5 or 3 metres long suitable for use with battery switches / fire extinguishers / fire extinguisher systems / boot or bonnet catches etc.
GE60B 1.5 metre black 't' handle pull cable
GE60R 1.5 metre red 't' handle pull cable
GE61B 3 metre black 't' handle pull cable
GE61R 3 metre red 't' handle pull cable

1.5m £10.99 3m £14.99

COMPETITION PEDAL PADS

	Supplied in sets with bolts and nylock nuts, manufactured from high tensile extra light aluminium anodised to protect. GE57... Silver GE57B.Blue GE57R Red
	IMPORTANT THIS PRODUCT IS FOR COMPETITION OR OFF-ROAD USE ONLY. THE PRODUCT MUST BE PROPERLY FITTED. DO NOT USE UNLESS THERE IS 50MM CLEARANCE BETWEEN PEDALS AFTER FITTING. IT MUST BE POSSIBLE TO OPERATE ANY PEDAL OVER ITS FULL TRAVEL WITHOUT INADVERTENTLY OPERATING OR INTERFERING WITH ANY OTHER PEDAL. IT IS ESSENTIAL TO RETAIN FULL PEDAL CONTROL AT ALL TIMES.

GE66 BONNET / BOOT LOCK FLUSH FITTING

		Chrome plated finish with flush face plate that does not protrude above body line. Supplied with 2 radial pin keys foe extra security. This bonnet lock complies with EEC Regulations £16.99
		IMPORTANT
		THIS PRODUCT MUST NOT BE USED UNLESS IT IS FITTED IN CONJUNCTION WITH THE ORIGINAL MANUFACTURERS OWN BONNET SAFETY CATCH, THIS ESPECIALLY APPLIES TO CARS WITH FIBRE GLASS BONNETS.

COMPETITION RUBBER BONNET/BOOT HOOK KITS

TOGGLE FASTENERS

> >	Supplied in pairs with all fixings, suitable for securing panels, bonnets or boots, many other uses. GE62 Small £6.99 GE63 Large £8.99		Chrome plated or black, supplied in pairs. Used for keeping panels, boots, tailgates shut at high speed. Standard or lockable types. GE64 Chrome plated large type GE64B Black coated large type GE65 Chrome plated small lockable with padlock eye GE65B Black coated small lockable with padlock eye

GE56 COMPETITION SPOT LAMP STEADY BARS

GE59 ADJUSTABLE COMPETITION SPOT LAMP STEADY BARS

	Supplied in pairs, can be bent to suit. Helps reduce spot lamp vibration. Also used to stabilise front spoilers / splitters		Supplied in pairs, made with left and right hand threads so the can be adjusted for tightness after fitting, helps stop lamp vibration. Also suitable for fitting and adjusting front spoilers and splitters.

DZUS FASTENERS

TEHF6-50/TS6-300
DZUS self-edjecting fasteners are designed for use on curved or contoured surfaces where ejection of the fastener is essential to remove the top panel
T1500/T150003
DZUS slide latch comprises a sliding bar which is supplied assembled to a housing/mounting plate which is rivetted to the panel

PLEASE CALL FOR PRICES

Used to either raise or lower the suspension on vehicles with coil springs. 1 Pack fits one spring